Dle 120 User Manual download pdf (Page 6)

Ignition Wires

(To Spark Plugs)

Ignition Control Switch Wire

(To On/Off Switch)

Pick-Up

Sensor Wire

(To Sensor

On Engine)

Tachometer

Lead/RPM Signal

Output

ELECTRONIC IGNITION

SYSTEM

Battery Lead

Charge Lead

On/Off Switch

(Not included)

Tachometer

(DLEG5525, not included)

OPTO Gas Engine Kill Switch

(DLEG9205, not included)

OPTIONAL

Ignition

Battery Lead

Ignition

Rx Batt

Lead

LED

KILL

SWITCH

4. Connect the ignition module battery to the on/off switch. Any

4.8-8.4V, 1000mAh and above capacity battery will work well for

this. Use heat shrink tubing to secure this connection. Optional:

Install the TX activated gas engine kill switch (DLEG9205) between

the on/off switch and the ignition as shown above. This is especially

important during the starting sequence as it requires the on/off

switch to be in the ON position before ignition can occur. The kill

switch LED should be installed on the exterior of the aircraft so that

it’s visible from the front of the aircraft. This is to ensure that the

person starting the engine is aware that the ignition is armed. If

properly installed as shown above an illuminated red LED indicates

that that the ignition is armed.

5. Install the ignition on/off switch on the aircraft so that it is easily

accessible.

6. Install the ignition module and battery

securely in the airplane forward area.

It is recommended that a thin piece

of foam rubber is placed between the

module and the mounting surface and

that Velcro

strap is used to hold the

module in place.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Dle 120 User Manual Page 6

Comments to this Manuals

Related products and manuals for Hardware Dle 120